User Manual

Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
7
Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
Installing the trim
13 Connect wire harnesses
1 From the inside of the door, make the following
connections:
2 Insert the plastic wire tie through the mounting clip
and secure the wires as shown in Figure 12.
Note: It is physically possible to connect the key
override sensor connector from the mortise case to the
battery connector from the wire harness. To avoid this
mistake, connect only the connectors with matching
wire colors.
Caution: When making the motor connection and
sensor connections, make sure:
◆ there are no loose wire connections where the
wires are inserted into the connectors
◆ the connectors are firmly mated
Wire connection Colors
No. of
wires
No. of
pins
Motor Yellow-gray 2 2
Key override sensor Gray 23
Deadbolt sensor Blue 23
RQE Orange-brown 2 3
Door sensing White 22
Latchbolt sensing Purple 22
Figure 12 Routing the wires
Route wire
harness on
the left side
of the fire
plate.
Mounting
clip and
wire tie
Dress wires so
that wire
connectors are
mated here.
Use electric
tape to affix
them as
needed.
Antenna wire