User Manual

Installation Instructions for Wi-Q™ Technology 9KQ Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
15
Installation Instructions for Wi-Q™ Technology 9KQ Cylindrical Locks
Completing the installation
21 Test lock
For 9KQ Locks with keypad:
To test the lock for proper operation before the lock is pro-
grammed, follow these instructions:
1 Press
1234.
2 Press
#.
The green light flashes and the locking mechanism
unlocks.
3 Turn the lever and open the door.
For all other locks:
To test the lock for proper operation before the lock is pro-
grammed, use the temporary operator card that came
with the lock. This card is for temporary use only. After
permanent cards have been programmed for the lock, the
temporary card should be deleted.
1 Use the temporary operator card to activate the lock.
Note: If the lock has a proximity card reader, it may
have already been activated by the presence of an
object near the card reader.
2 Use the temporary operator card to access the lock.
3 The green light flashes and the locking mechanism
unlocks.
4 Turn the lever or knob and open the door.
5 With the door closed, insert and turn the key to
unlatch the door.
If the mechanism doesn’t unlock, refer to the follow-
ing table. For additional troubleshooting instructions,
see the Service Manual
.
LEDs Sounder You should
Single
red flash
— Use the card at a moderate
speed.
Red
flashes
3 short
tones
Use the temporary operator
card provided with the lock.
Green
flashes
— Check the motor connection.
— — Check the battery connection.