User Manual

Installation Instructions for Wi-Q™ Technology 9KQ Cylindrical Locks

Preparing the door and door jamb

BEST ACCESS SYSTEMS

a Product Group of Stanley Security Solutions, Inc.

5 Use drill jig to drill through-bolt holes

1 Press the drill jig (KD303) onto the door, engaging it

with the latch tube prongs (see the close-up in

Figure 5). Make sure the front edge of the jig is parallel

with the door edge.

2 Drill the through-bolt holes (5/16″ diameter) halfway

into the door.

3 Turn over the drill jig and repeat steps 1 and 2 from the

opposite side of the door.

Note: Replace the drill jig after 10 door preparations.

Figure 5 Installing the drill jig and drilling the

through-bolt holes

Latch

tube

prongs

Drill upper through-bolt

hole.

Drill lower through-bolt hole.

Inside of door