User Manual

161

Programmer Override at Keypad Reader

When an AMS User is assigned a Programmer Type, that user can present their

credential and perform the following.

Note PC refers to Programmer Credential.

Deep Reset

At times it may be necessary to perform a Deep Reset on a Controller. For exam-

ple, when you install a dial up gateway modem, you must temporarily clear reader

data. If the reset button inside the Controller housing is not accessible, you can

use the Programmer Override to perform a Deep Reset. You can also perform a

deep reset from within Conﬁgurator.

To Perform a Deep Reset from within Conﬁgurator

1 In the Conﬁgurator’s Readers Tab, navigate to the desired reader using the

Segment Tree.

2 In the list on the right, right-click on the reader and select Deep Reset from the

drop-down list. Reader data will be cleared.

3 To bring the reader back into the software, you must perform a standard sign

on procedure.

Note If the reader does not respond and perform the Deep Reset within ﬁve minutes, the

action will be aborted.

Item

WDC WAC Omnilock

Function

Programmer

Code

PC# PC PC Momentary Unlock.

Soft Reset PC# + 1# PC + 1111 PC + 1 Soft resets device.

Motor Reset PC# + 2# PC + 2222 PC + 2 Resets the motor drive.

Comm.

Processor

Reset

PC# + 7# PC + 7777 PC + 7 Resets the communication

processor.

Motor Test PC# + 8# PC + 8888 PC + 8 Runs motor test.

Deep Reset MC# + 9# MC + 9999 MC + 9 Deep resets device.