User Manual

118
Figure 82 I/O Events Setup
From here you can create an event, check the device’s current state of operation,
define an access level, associate it with a reader in the system, define a trigger
state (high or low), and define the type of event to be triggered.
Note: The system recognizes the WAC as any other “reader” in the system. It will appear
in the referenced dialog boxes as a reader; however, you will recognize it by its
MAC address.
6 Click the Add button. The system creates an Event ID and adds it to the list in
the left hand column.
7 Enter a name for the event, such as Fire Alarm A.
8 Under the Settings Category, click the Readers field and click the ellipsis but-
ton.
9 This will open up a new window. See Figure 83. Select a device from the Read-
ers in Segment section that will be associated with the event.
10 Click Add << to add it to the list of Readers Associated with I/O Event list.