User's Manual

12
Setup Checklist
Wi-Q AMS is set up in eleven basic tasks. Completing these tasks will ensure you
get your system up and running as quickly and efficiently as possible.
Some tasks are performed at the Host computer and some at the segment site.
It is appropriate to perform some tasks concurrently, for example, you may have
someone prepare your computer and install the software concurrently with site
plan development and hardware installation. However, you must have the soft-
ware installed and Portal Gateways ‘online’ before you can sign on controllers.
Note System setup does not proceed in a linear manner. The following references
prompt you to skip around within this User Guide.
 Task 1: Develop a Site Plan, page 17.
 Task 2: Position Portal Gateways, page 21.
 Task 3: Prepare your Computer, page 33.
 Task 4: Gather and Organize Segment Data, page 43.
 Task 5: Install Software, page 45.
 Task 6: Create your Segment, page 63.
 Task 7: Add and Configure Portal Gateways, page 67.
 Task 8: Install Portal Gateways, page 24.
 Task 9: Install Door Hardware, page 28.
 Task 10: Sign On and Configure Controllers, page 84.
 Task 11: Configure AMS Software, page 96.