R Recliner Risers TM Comfort to live. Freedom to move.
Items Included: Tools Required: Exploded View: Scissors, Screwdrivers – 1 Phillips, 1 Flathead
Installation Instructions: Separate the hook and loop fastener into 2 pieces. Cut one piece in half (fig.1) creating two 2” pieces (C) that will later be attached to the chair base. With the remaining fastener, cut two ¾” strips. Discard the rest. Peel off the adhesive backing and place on each Rocker Limiter as shown (D). Turn the chair on its left side: the leg extension handle will be visible (fig. 2). Using a flathead screwdriver, pry the plastic floor protectors from each corner of the chair base.
Turn the chair over onto its right side. Repeat steps in figure 2 and figure 3 for the other side of the chair. Make sure that the Recliner Riser (B) is in front this time and Recliner Riser (A) is in the back. When finished, return the chair to its upright position. NOTE FOR SWIVEL BASED CHAIRS: Base must be switched to a regular base prior to installation. Most chair manufacturers will do this for a small fee.
WARNING: Please read before using this product. 1. Serious injury can result if Recliner Risers are not properly installed. If Recliner Risers are not securely fastened to the recliner base, the recliner may become improperly balanced, which may result in the user to tip and fall. If you notice any instability in your recliner after installation, please review the instructions or contact Stander at 1-800-5069901. Standers Inc.
