Instructions / Assembly

1120 Security Pole & Curve Grab Bar – Bathtub Edition V 1.0, December 14, 2022
3. Ensure that the installation location is clean and dry prior
to installation. Extend A to fit over the side of the
bathtub, then rotate the knob clockwise to secure A to
the tub as shown in FIGURE 3. Do NOT fully tighten.
FIGURE 3
4. Twist C to its highest position and insert D into B
as shown in FIGURE 4. Note: If washers fall off,
ensure that they are reinstalled prior to inserting
D into B. Place the plastic washer directly under
C, then place the metal washer under the plastic
washer.
FIGURE 4
5. Determine the distance between the top of the bathtub and the ceiling. For distances less than 90” (2.3M), see
Step 5-A. For distances greater than 90” (2.3M), see Step 5-B.
FIGURE 5
Step 5-A
For distances less than 90” (2.3M), install
the longer plastic sleeve, F, over D.
Step 5-B
For distances greater than 90” (2.3M),
install the shorter plastic sleeve, G, over D.