User Manual

Page 67
GX1600/GX1700
9.8.1.2 DSC Position Report Call by Manually Entering a MMSI
You may enter an MMSI number manually to contact a vessel without storing
the MMSI in the individual/position call directory.
1. Press the
key. The “
DSC Menu
” will
appear.
)TQWR
#NN 5JKRU
215 4GSWGUV
215 4GRQTV
&KUVTGUU#NGTV/5)
&5% /GPW
+0&+8+&7#.
37+6
5'.'%6
)TQWR
+PFKXKFWCN
#NN 5JKRU
215 4GSWGUV
&KUVTGUU#NGTV/5)
&5% /GPW
215 4'4146
37+6
5'.'%6
/#07#.
37+6
5'.'%6
;#'57
*QTK\QP
$QD
5VCPFCTF
5WP .KIJV
215 4GRQTV %CNN
2. Press the / key to select “
POS
REPORT
”. (To cancel, press the soft
key.)
3. Press the
soft key. The transceiver
will beep, and the “
POS Report Call
”
menu will appear. The previous six position
report contacts will be listed.
Press the soft key.
4. Press the
/ key to select “
MANUAL
”,
then press the soft key.
5. Press the
/ key to select the rst number
of the MMSI which you want to contact, then press
the soft key to step to the next digit.
QUIT
SELECT BACK
Input MMSI
ID:---------
-POS Report Call-
QUIT
SELECT BACK
Input MMSI
ID:345678901
-POS Report Call-
-Category-
ROUTINE
QUIT
SELECT
Safety
6. Repeat step 5 to set the MMSI number.
7. If a mistake was made entering in the MMSI
number, repeat pressing the
soft key until
the wrong digit is selected, then press the
/ key to correct the entry.
8. When finished entering the MMSI number, press
and hold the
soft key.
9. Press the
/ key to select the nature
of call (“
ROUTINE
” or “
SAFETY
”), then press the
soft key.
NOTE
“
SAFETY
” is normally used as the category for position report calls.
However, “
ROUTINE
” should be selected when calling a vessel with
radios of certain legacy models that cannot accept position report
calls categorized as “
SAFETY
”.