User Manual

Page 35
GX1600/GX1700
5. Press the / key to select a desired
channel to be scanned, the press the
soft key. “
MEM
” icon appears on the
display, which indicates the channel has
been selected to the scan channel.
-Scan Memory CH-
QUIT
ADD DELETE
20
19A MEM
18A
17
20A MEM
16 MEM
6. Repeat step 5 for all the desired channels to be scanned.
7. To DELETE a channel from the list, select the channel then press the
soft key. “
MEM
” icon disappears from the display.
8. Press the
soft key three times to return to radio operation.
8.9.3 Memory Scanning (M-SCAN)
1. Adjust the SQL knob until the background noise disappears.
2. Press one of the soft keys, then press the
soft key. “
M-SCAN
” appears on the display. Scan-
ning will proceed from the lowest to the highest
programmed channel number and preset channel
(described in the next chapter) and will stop on a
channel when a transmission is received.
M-SCAN
12:56
LOC AM
25W USA
N
W
DISTRESS
33 37.120
118 09.580
3. The channel number will blink during reception.
4. To stop scanning, press the
key or the soft key.
8.9.4 Priority Scanning (P-SCAN)
By default, Channel 16 is set as the priority channel. You may change the
priority channel to the desired channel from Channel 16 by the General
Setup mode, refer to section “11.5 PRIORITY CHANNEL”.
1. Adjust the SQL knob until the background noise disappears.
2. Press one of the soft keys, then press the
soft key. “
P-SCAN
” appears on the display. Scan-
ning will proceed from the lowest to the highest
programmed channel number and preset channel
(described in the next chapter) and will stop on a
channel when a transmission is received.
P-SCAN
12:56
LOC AM
25W USA
N
W
DISTRESS
33 37.120
118 09.580
3. To stop scanning, press the key or press one of the soft keys, then
press the soft key.