Operation Manual

GX1150Page 48
6. Press the key again to transmit the
Group Call signal.
7. After the GROUP CALL is transmitted, all
the radios in the group will switch to the
channel which is selected on step 5 above.
8. Press the key to return to radio opera-
tion mode.
9. Listen to the channel to make sure it is not
busy, then key the microphone and call the
other vessels you desire to communicate
with.
Manual Calling
You may enter an MMSI number manually to contact without the Setting up the
Group call number.
1. Press the key. The “DSC MENU” will ap-
pear.
2. Press the / keys to select “GROUP”.
(To cancel, press the key or key.)
3. Press the key. The transceiver will beep,
and the “Group Directory” will appear.
4. Press the / keys to select
MANUAL”, then press the key.
5. Press the / keys to scroll through
numbers, 0-9. To enter the desired number and
move one space to the right press the key.
Repeat this procedure until all nine space of the
MMSI number which you want to contact are en-
tered.
6. If a mistake was made entering in the MMSI num-
ber, repeat pressing the microphone’s key
until the wrong number is selected, then press the
/ keys to correct the entry.
7. When finish the entering the MMSI number, press
and hold the key.