Operation Manual

Page 94 CP190i and CPF190i
13. ADVANCED SETTINGS
The Advanced Setup menu allows customization of many GPS functions, Alarms and
NMEA interfacing.
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
While in this menu you will see many selections which are described in the next sections.
13.0 INPUT/OUTPUT (NMEA, AIS, RADAR)
13.0.0 Input
The CP190i has 2 Inputs and 3 Outputs connections. The CPF190i has 1 Input and 2
Outputs connections.
These ports may be set up to receive and output the following.
· NMEA-0183 - NMEA devices* set to 4800 Baud (default setting)
· Fish Finder: Only for CP190i: FF525 50/200kHz Black Box Fish Finder - refer to Fish
Finder Owner’s Manual
· C-COM - C-Weather refer to Section 15
· Radar - SI-TEX optional Radar refer to Radar Owner’s Manual
· AIS 38400 - AIS Receiver, refer to Section 14
· MOBILARM - Mobilarm receiver, refer to Section 16
· Disabled - allow the port to be disabled.
NOTE*
RS232 not opto-isolated electrical interface.
NOTE
When a Port is configured, both the Input and Output have the same setting.
Port1 is set to Radar, both the Input and Output wires are set to SI-TEX proprietary Radar
sentences. This means other devices should not be connected to the Input or Output wires.
13.0.1 Ouput
The ports may be setup to output NMEA sentences. The table below shows the default
setting each port.
CP190i
Sentence Port1 Port2 Port3
GLL On On On
VTG Off Off Off
BWC Off Off Off
WCV Off Off Off