Operation Manual

Page 86 CP190i and CPF190i
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
WINDOW SETUP and press [ENT] and press
[ENT] or move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
NAVIGATION PAGE and press [ENT] and
press [ENT] or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint up or down to select
COMPASS TAPE and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the right until the Chart page is shown.
Figure 12.2 - Navigation page with Compass Rose
Figure 12.2a - Navigation page with Compass Tape
NOTE
The COG heading is computed and supplied to the plotter from the internal GPS or external GPS.
12.3 HIGHWAY PAGE
Shows a 3D view of the vessel travelling through the water when Navigating to a destination
point, Mark or following a Route. Press [ZOOM IN] or [ZOOM OUT] to change the highway
scale.