Operation Manual

CP190i and CPF190i Page 81
12.0.5 Turning Off Information on Icon Points
The GPS Chart Plotter allows you to select to see information On Points, On All items or
to turn this function Off. The default setting is On Points.
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight
GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
AUTO INFO and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob up or down to highlight
OFF, ON POINTS or ON ALL and
press [ENT] or move the ShuttlePoint knob to the right.
5. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page appears.
Figure 12.0.5 - Example of Auto Info settings
12.0.6 Display Mode
Selects from a pre-defined table what cartographic objects are displayed and which display
options are set. Preprogrammed settings are user selectable from Full, Medium, Low,
Radar (reduces the information on the display to simulate items that would be shown on a
Radar display. Please note this function is not actually showing Radar information it is only
showing what typically would be shown by a separate dedicated Radar display), Tides,
Custom (default mode). To change to one of the preprogrammed settings
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
CHART CONFIGURATIONS and press [ENT]
or move the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
DISPLAY MODE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob up or down to select the preset and press [ENT].
5. Press [CLR] or move the ShuttlePoint knob to the right until the Chart page is shown.
Figure 12.0.6 - Display Mode settings