Operation Manual

Page 74 CP190i and CPF190i
STEP UNIT Allowable selection are Distance or Time
DISTANCE User adjustable Distance interval of when Track point is laid down on the Chart page.
TIME User adjustable Time interval of when Track point is laid down on the Chart page.
10.1 TRIP LOG
10.1.0 Using the Trip Log
On the Chart, Navigation, Highway and NMEA Data pages the windows may be customized
to show Trip Log information.
1. Select one of the pages listed above, press and hold [MENU]. You will notice one of the
data boxes will be highlighted.
2. Press [ENT] and move the ShuttlePoint knob to highlight
TLOG, press [ENT] or move
the ShuttlePoint knob to the right.
3. A popup window will be shown with
Nm (Nautical Mile), Sm (Statute Mile), Km
(Kilometer),
Nm+Mt, Nm+Ft and RESET. Move the ShuttlePoint knob to select the
desired units of measure and press [ENT] or move the ShuttlePoint knob to the right.
4. Press [CLR] or move the ShuttlePoint knob to the right until the selected page (Chart,
Navigation, Highway or NMEA Data Page) is shown.
10.1.1 Setup / Reset
When Trip Log is selected in one of the data windows and you want to reset the log:
1. Press and hold [MENU] until a field is highlighted (it will be shown in a yellow frame).
2. Move the ShuttlePoint knob to highlight the Trip Log window
TLOG and press [ENT].
3. A popup window will be shown. Move the ShuttlePoint knob to
TLOG and press [ENT].
4. Another popup window will be shown. Move the ShuttlePoint knob to
RESET and press
[ENT].
5. A warning popup window will be shown to confirm if you want to reset the Trip Log. Move
the ShuttlePoint knob to highlight
YES and press [ENT]. The Trip Log is now reset.
6. Press [CLR] to store and exit the editing mode.
Figure 10.1. 1 - Trip Log Reset