Operation Manual

Page 54 CP190i and CPF190i
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
SAFETY STATUS BAR and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows the following selections:
ON: The Safety Status Bar is shown
OFF: The Safety Status Bar is not shown
ICON: In this mode the Safety Status Bar is not shown, rather a Warning Icon
will be shown in the top right corner on the chart page when an alarm condition is
met.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint
knob to the left a few times.
6.0.6 Satellite Imagery
This function allows to overlay the Satellite image for background chart. When it is set On,
the Palette is set to Normal to display the proper colors.
NOTE
The satellite image is only shown on 100Nm, 50Nm and 20Nm scales.
To activate this function follow the procedure below:
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
SATELLITE IMAGERY and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows two selections,
ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the Chart page is shown.
Figure 6.0.6 - Example of Satellite Imagery
6.0.7 Currents Prediction
The worldwide database with Tidal stream information is available with MAX C-CARDs.
When data/time is available, Tidal stream arrows are shown on the charts, indicating the
direction and strength of the Tide: