Operation Manual

CP190i and CPF190i Page 53
6.0.4 Dynamic Nav-Aids
This function allows the blinking of the Nav-Aids to be turned On or Off. The blink period and color
of each Nav-aid is read from the Nav-Aid attributes stored on the optional C-MAP B
Y JEPPESEN
C-CARD. When the ship is inside the Nav-Aid nominal range, the light of the Nav-Aid will start
blinking. When Dynamic Nav-Aids option is set to On, when the flashing light is Off, or when fix
position is out of the sector, the light color is displayed by using a faint light color.
To activate this function follow the procedure below:
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight
MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
DYNAMIC NAV-AIDS and press [ENT] or move
the ShuttlePoint knob to the right.
4. The menu now shows two selections,
ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the chart page is shown.
6.0.5 Safety Status Bar (DSI - Data Safety Indicator)
When the Safety Status Bar is enabled, a status bar with six boxes show the status of certain
functions. Any warning or alarm condition is identified by the red color to indicate possible risk.
Figure 6.0.5 - Safety Status Bar
To activate this function follow the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].