Operation Manual

Page 48 CP190i and CPF190i
1. Turn Off the GPS Chart Plotter.
2. Insert the Chart Update Card into the slot.
3. Press and hold [PWR] to turn the GPS Chart Plotter On.
4. The GPS Chart Plotter’s display will show a message that the Built-In Charts are being
uploaded.
5. After uploading the GPS Chart Plotter will check to ensure the charts have been loaded
correctly and show a message.
NOTE
If the message shows the charts were not updated correctly, follow steps 1-4 again. If the GPS
Chart Plotter shows a error message again, contact C-MAP USA at [phone] for assistance.
5.1 INSERTING THE OPTIONAL MAX C-CARD
Hold the C-CARD by the long inclined side so that you can see the C-MAP BY JEPPESEN label.
Figure 5.1 - Inserting C-CARD
Open the door, gently push the C-CARD into the slot: push the C-CARD in as far as it will
go, then close the door.
Figure 5.1a - Inserting C-CARD (details)
NOTE
The small connector below the C-CARD is only used by STANDARD HORIZON repair technicians.