Operation Manual

CP190i and CPF190i Page 27
The GOTO key
This key is very useful when you desire to start navigating (goto) to a destination point. When
pressed, a popup window will be shown allowing you to select to start navigating to the a
Mark, a Route or the position of the cursor.
To stop navigation to a point, press [GOTO] and select Stop in the popup window.
The MARK key
This key places a Mark under the ship’s position when in Home Mode. When the cursor is
shown and [MARK] is pressed it will place a Mark under the location of the cursor.
The ROUTE key
When pressed places a Waypoint. Succeeding presses place more Waypoints to form a Route.
The PWR key (Backlight and Contrast)
Press and hold [PWR] to turn the GPS Chart Plotter On or Off. Once on, press [PWR] to
show and change the Contrast and Backlight settings.
The MOB key
When pressed the GPS Chart Plotter automatically places a Mark on the Chart page under
the boat’s position to aid in the rescue or a person that may have fallen aboard. To stop
navigating, press [GOTO], select
STOP and press [ENT].
The FIND key
A dedicated key that allows searching the optional C-MAP B
Y JEPPESEN NT
+
/MAX C-CARD
for Port Services, Ports, Tide Stations, Wrecks, Obstructions, Points Of Interest, Lakes
Information, Lakes By Name, User Points, GPS Coordinates or Information on any point on
the chart.
3.1 GETTING STARTED
The Getting Started section will take you through the frequently used operations and assist
you to customize the look of the GPS Chart Plotter.
3.1.0 Power On, Off and ShuttlePoint Knob operation
1. Press and hold [PWR] until the display shows the Start-Up page (see the following
picture). To turn Off, press and hold [PWR] until the display turns Off.
Figure 3.1.0 - Example of Start-Up page on CPF190i
2. When the power is first turned on two pages the Start-Up page and the Caution pages