Operation Manual

CP190i and CPF190i Page 23
Figure 2.8 - FF525 50/200kHz Black Box Fish Finder
NOTE
The FF520 is also compatible.
2.9 RADAR ANTENNA (USA ONLY)
Please refer to Par. “1.3 Radar Unit supplied by SI-TEX USA”. The Radar antenna includes
the necessary electronics to deliver Radar information to a compatible STANDARD
HORIZON GPS Chart Plotter, and is supplied with mounting hardware kit, interconnection
cable and a Radar Junction Box. Please refer to the Radar Installation Manual and Radar
Operation Manual available at www.standardhorizon.com.
2.10 PERSONAL COMPUTER CONNECTIONS
The GPS Chart Plotter can be connected to output Marks and Routes to many available PC
programs. To send or receive User Points the PC Program must be able to receive NMEA
WPL and RTE sentences. Refer to the table below for connection to a Serial DB9 connector.
Pin PC DB9 connection Port 1 connection
2 Receive Brown
3 Transmit Blue
5 Signal ground Green
By default Port1 is set to receive or send User Points to and from a PC. The GPS Chart
Plotter may be set up to send and receive the User Points on a different Port using the
following procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
SEND/REC RTE & MARKS and press [ENT]
or move the ShuttlePoint knob to the right to show the popup window.
5. Move the ShuttlePoint knob to desired Port and press [ENT].
The PC COM settings are:
· Baud Rate : 4800
· Parity : None
· Data Bits : 8
· Stop Bits : 1
· Flow Control : None
The format of the sentences that are sent: