Operation Manual

Page 18 CP190i and CPF190i

2.4.0 CP190i Connection Table

Power Data Cable

Pin Wire Color Description Connection Example Additional Comments

1 Black Battery Ground Connect to Battery Ground

2 Red Battery Positive Connect to Battery Positive

3 Green NMEA Common Common (ground) for NMEA devices**

4 Blue Port1 Input Connect to Output of NMEA devices** Default is NMEA 0183

5 Brown Port1 Output Connect to Input of NMEA devices** Default is NMEA 0183 with GGA, GLL, RMC,

DBT, DPT, MTW, VHW and XTE sentences

6 Grey Port2 Input Connect to FF525 Default is Fish Finder

7 White Port2 Output Connect to FF525 Default is Fish Finder

8 Yellow Port3 Output Connect to Input of NMEA devices** Default is NMEA 0183 with APA, APB, BOD,

GGA, GLL, RMC and BOD sentences*

NOTE* AUTOPILOT CONNECTION

Care must be taken when connecting the GPS Chart Plotter to an Autopilot. Normally Port3 (Yellow

wire) will be used to connect to an Autopilot input, however older autopilots may not be able to read

the sentences due to the talker ID that is being used (II Integrated Instrument). If the Autopilot

connections are made to Port3 (Yellow wire) and the Autopilot is not reading the sentences, change

the connections to Port1 (Brown wire) and change the sentences to APA, APB, BOD, GGA, GLL,

RMC and XTE.

NOTE**

RS232 not opto-isolated electrical interface.

2.4.1 CP190i Connections

2.4.1.0 DC Power Connection

Battery

10-35Vdc

Red

Fuse

Black

Switch

PWR & ACC 1 Cable

Optional WAAS

GPS Antenna

CP190i