Operation Manual

CP190i and CPF190i Page 109
16.4.1 Goto PTX
When Goto is selected on the GPS Chart Plotter, navigation will start to the PTX icon
location. After the GPS Chart Plotter has received a PTX MOB alarm, using the ShuttlePoint
knob move the cursor over the PTX to navigate to and then press [ENT], select
GOTO using
the ShuttlePoint knob and press [ENT].
Figure 16.4.1 - Example of Goto PTX
If the navigation is set to the selected PTX icon, to terminate the navigation press [ENT],
select
STOP GOTO using the ShuttlePoint knob and press [ENT].
Figure 16.4.1a - Example of Stop Goto PTX
16.4.2 The MOBILARM Alarm Status List
The MOBILARM Alarm Status List shows the list of all PTX that the GPS Chart Plotter has
received an alarm from. To review the page:
1. Select the Chart page.
2. Press [MENU] to show the Main menu.
3. Move the ShuttlePoint knob to highlight
USER POINTS and press [ENT].
4. Move the ShuttlePoint knob to highlight
MOBILARM and press [ENT].
This page allows you to:
GOTO Activates navigation to the selected PTX. Once the navigation has been activated, close all
menus/data pages (if open) and center the chart selected PTX.
DELETE Deletes the selected PTX.
SHOW Centres the chart on the selected PTX.
SHOW ALL Selects the best chart scale to see all PTX icons on the chart at the same time.