Operation Manual

Page 108 CP190i and CPF190i
Figure 16.3.0a - Example of PTX warning window
It is possible to Goto (navigate) to the received MOBILARM PTX position (see Par. 16.4.1)
or open the MOBILARM Alarm Status List page (see Par. 16.4.2). Selecting Goto or Alarm
Status List will mute the Audible Alarm.
NOTE
When the same PTX is received again:
a. If the received PTX is not the active one, the user must confirm to navigate to it.
b. If the received PTX is the active one, navigation data is updated. The PTX icon appears at the
new position and a popup warning window appears.
16.4 PLACING CURSOR ON THE PTX ICON
Moving the ShuttlePoint knob so the cursor is over the PTX icon on the Chart page will show
an information window and allow you to Goto the location of the PTX, delete the PTX icon
or show the Alarm Status list as shown below.
Figure 16.4 - Example of PTX information window
16.4.0 Delete PTX
The Delete PTX function permanently removes the selected PTX from the MOBILARM
Alarm Status List and from the Chart page.
Using the ShuttlePoint knob, move the cursor over the PTX icon and then press [ENT],
select
DELETE using the ShuttlePoint knob and press [ENT]. A warning popup window will
be shown. Select
YES and press [ENT].