Operation Manual

CP590 Page 97
NOTE
A Target is removed from the screen if data is not received for 10 minutes.
The maximum number of tracked Class A or B targets is 200.
This information is updated every 3 seconds to 6 minutes depending on speed and rate of turn,
enabling the track of the vessels in range to be plotted.
Figure 14.0 - AIS Symbols
14.1 AIS SETUP MENU
To configure the CP590 to receive AIS data, follow the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
AIS SETUP and press [ENT] or move the
ShuttlePoint knob to the right. The AIS menu appears on the screen. The available
functions are described in the following table.
Display : Turns the display of AIS Targets overlay on the cartography On or Off. The default setting is On.
Activation Range : Defines the range from the fix within which the AIS Target becomes active. The values
allowed are from 0.1 to 20Nm. The default setting is 5Nm.
CPA Alarm : Turns On or Off the alarm. The default setting is On.
CPA Limit : The values allowed are from 0.1 to 10 Nm. The default setting is 0.5Nm.
TCPA Alarm : Turns On or Off the alarm. The default setting is On.
TCPA Limit : The values allowed are from 1 to 30 Min. The default setting is 10 Min.
SART/MOB/EPIRB Test: Turns On or Off receiving of AIS-SART, AIS-MOB or AIS-EPIRB test alerts.
14.2 QUICK INFO ON AIS TARGET
By placing the cursor over a AIS Target icon using the ShuttlePoint knob, the following
information is displayed. Press [E
XPAND] to select the Enhanced AIS Page with information
related to the selected AIS object (see the following Par. 14.6).
Figure 14.2 - Quick Info on AIS