Operation Manual

Page 86 CP590
12.5.0 GPS Setup Menu
From the GPS Status page it is possible to activate the GPS Setup menu.
1. Press [MENU], move the ShuttlePoint knob to enter
GPS STATUS page and press
[ENT].
2. Press and hold [ENT]. The GPS Setup menu
1
appears on the screen. See the following
table:
Restart GPS : Restarts all GPS processes. Once executed, the message "Done" is shown.
Navigation Speed : Allows setting the Navigation Speed among Low and High. The default setting is High.
Speed Filter : Allows to resolve erratic speed readings in rough seas. Available values are Off, Low,
Medium, High. The default setting is Off.
Differential Correction Source : Allows setting what kind of Differential Correction will be used by the GPS between
WAAS-EGNOS and none. The default setting is WAAS-EGNOS.
3. Move the ShuttlePoint knob to highlight the preferred item and press [ENT].
4. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the menu disappears.
Figure 12.5.0 - GPS Setup menu
1
NOTE
1
The GPS Setup menu changes depending on the type of the external GPS used.
12.5.1 WAAS/EGNOS Setting
From the GPS Status page it is possible to disable the WAAS/EGNOS function.
1. Press [MENU], move the ShuttlePoint knob to enter
GPS STATUS page and press
[ENT].
2. Press and hold [ENT]. The GPS Setup menu appears on the screen.
3. Move the ShuttlePoint knob to highlight
DIFF CORRECTION SOURCE and press
[ENT].
4. Move the ShuttlePoint knob to highlight
None (to disable) and press [ENT].
5. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the menu disappears.
12.6 NMEA DISPLAY PAGE
The CP590 is capable of displaying information in the customizable data windows from
external NMEA-0183 devices. Depth Sounder, Speed Log with Temp, Wind Speed and
Direction, Flux Gate Compass, and GPS information can be shown in any of the boxes. The
NMEA sentences read from external devices are: BWC, DSC, DSE, GGA, GLL, GSA, GSV,
HDG, HDM, HDT, RMC, VHW, VTG, DPT, DBT, MTW, VWR, VWT, TLL, WPL, RTE. To
display the desired NMEA Display page follow this procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight
NMEA DISPLAY and press
[ENT].