Operation Manual

CP590 Page 83
12.1 CUSTOMIZING CHART SETTINGS
The CP590 also allows you to customize items shown on the chart (discussed in above
sections) instead of using a pre-defined table discussed in Par. 12.0.5 “Display Mode”.
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight
CHART CONFIGURATIONS and press [ENT]
or move the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
DISPLAY MODE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
Custom and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up or down to select the desired item within the groups
Marine Settings, Depth Settings, Land Settings, Chart Settings or Underwater Settings
and press [ENT]. See the above sections for details on selections.
12.2 NAVIGATION PAGE
The Navigation page is useful to show information when heading to a destination, following
a compass heading or navigating to a Mark or a Route. The default page is shown with a
Compass Rose, however this can be customized to show a Compass Tape.
1. To change to show the Compass Tape, select the Chart page, press [MENU]. Move the
ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
WINDOW SETUP and press [ENT] and press
[ENT] or move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
NAVIGATION PAGE and press [ENT] and
press [ENT] or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint up or down to select
COMPASS TAPE and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the right until the menu disappears.
NOTE
The COG heading is computed and supplied to the CP590 from the external GPS.
Figure 12.2 - Navigation page with Compass Rose