Operation Manual

CP590 Page 71
11. USER C-CARD
The optional User C-CARD is used to backup Marks, Routes, and Tracks stored in your
CP590's memory. In the USA the User C-CARD is available directly from Jeppesen Marine
at 800/424-2627. The User C-CARD is similar to a backup disk used with a PC, in case you
have to clear the RAM to resolve an issue or load new software, or if you would like to transfer
Waypoint, Track and Route information from one STANDARD HORIZON GPS Chart Plotter
to another.
11.0 USER C-CARD MENU
This optional card is similar to using a floppy disk or memory stick on a PC to backup your
files or to transfer the information that you have stored to a friends GPS Chart Plotter. The
information shown below will assist you to transfer the User Points, Routes and Track
history to the optional User C-CARD. To open the User C-CARD page:
1. Press [MENU], move the ShuttlePoint knob to highlight
USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight
USER C-CARD and press [ENT].
Figure 11.0 - User C-CARD Menu
11.0.0 Formatting the Optional User C-CARD
1. Press [MENU], move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight
USER C-CARD and press [ENT].
3. Move the ShuttlePoint knob to highlight
FORMAT and press [ENT].
4. A popup Warning window will to confirm you want to format the User C-CARD.
5. Select
YES and press [ENT] to confirm (select NO otherwise). The format of User
C-CARD must be done before using a new User C-CARD: this operation prepares the
User C-CARD to receive and store information.
NOTE
Formatting permanently erases all files previously saved on the User C-CARD.