Operation Manual

CP590 Page 65
Figure 9.6.0 - GOTO ROUTE procedure (1)
5. Move the ShuttlePoint knob to the highlight the desired Route and press [ENT].
6. On the Chart page, a circle with a flag is shown on the first leg of the Route you chose
and a navigation line is shown, indicating the CP590 is navigating to the first Waypoint
in the Route.
Figure 9.6.0a - GOTO ROUTE procedure (2)
9.6.1 Using the ShuttlePoint knob
1. On the Chart page move the ShuttlePoint knob until the cursor reaches the starting point
of the Route.
2. Press [GOTO] to start following the Route.
3. Press [CLR] twice to revert to Home Mode.
9.7 DELETING A ROUTE
To delete a Route follow the procedure below:
1. Press [MENU], move the ShuttlePoint knob to highlight
USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight
ROUTE and press [ENT].
3. Move the ShuttlePoint knob to highlight
DELETE and press [ENT] or move the
ShuttlePoint knob to the right.
4. A Warning message appears to confirm. Move the ShuttlePoint knob to highlight
YES
and press [ENT]. The Route has been deleted.
WARNING
An active Route (one that you are navigating to) cannot be deleted until you stop navigating to the
Route.