Operation Manual

CP590 Page 59
5. The CP590 is in Cursor Mode, to switch to Home Mode press [CLR] so the vessel will
stay in the center of the page.
6. Two Soft Keys are also shown that allow you to quickly switch to the Highway page or
to stop navigation.
7. To stop navigation, press [GOTO] and a Warning window is shown. Move the
ShuttlePoint knob to highlight STOP and press [ENT].
Figure 7.4.0c - Warning window
7.4.1 Goto Route
When a Route is shown on the Chart page, move the cursor over the designed Waypoint
and press [GOTO]. For more information about Routes refer to Chapter 9.
7.4.2 Goto Mark
1. Move the ShuttlePoint knob to an open position no buoy, warning etc. under the cursor)
on the Chart page.
2. Press [GOTO] to show the GOTO popup window.
3. Move the ShuttlePoint knob to highlight
MARK and press [ENT] to show the Marks/
Waypoints List.
4. Move the ShuttlePoint to highlight the desired Mark or Waypoint and press [GOTO].
5. You will notice a circle is drawn around the Icon symbol. This means the CP590 is now
navigating to the point.
6. Press [CLR] to switch to the Chart page or Highway page to start navigation to the point.
7.4.3 Stop Navigation to Destination
When the last navigation point is reached (last point of navigated route or single navigation
point), navigation stops. You can decide whether the navigation is automatically stopped
or if the user confirmation is required (see Par. 13.1).
If confirmation is required, when the Destination is reached a WARNING window is shown.
Move the ShuttlePoint knob to highlight
YES and press [ENT] to stop the navigation:
Figure 7.4.3 - Warning window