Operation Manual

Page 58 CP590
7.4 GOTO CURSOR, ROUTE AND MARK
The CP590 can easily be set to start navigating to the cursor on the Chart page, a saved
Mark or a Route that was created.
7.4.0 Goto Cursor
1. Move the ShuttlePoint knob to the exact position you want to navigate to.
2. Press [GOTO] and a GOTO popup window will be shown.
Figure 7.4.0 - GOTO menu (1)
3. Move the ShuttlePoint knob to highlight CURSOR and press [ENT].
Figure 7.4.0a - GOTO menu (2)
4. The CP590 is now navigating from your current position to the location selected at step
1. A bearing line between the vessels location and the destination point is shown. A
popup window shows the Distance (DST) and Bearing (BRG) from the vessels location
to the destination point.
Figure 7.4.0b - GOTO menu (3)