Operation Manual

CP590 Page 23
The alphanumeric Keys
The 10 alphanumeric keys are used for entering in alphanumeric data. Pressing the
alphanumeric key the first time enters the first letter, the second time enters the second
letter, the third time enters the third letter; the forth time enters the number. After a short time
the entered character (letter or number) is confirmed and the cursor is moved to the next
location.
NOTE
To enter data it is possible to use also the ShuttlePoint knob. Pressing the ShuttlePoint knob up/
down changes the value; pressing the ShuttlePoint knob left/right moves the cursor to the previous/
next location.
3.1 GETTING STARTED
The Getting Started section will take you through the frequently used operations and assist
you to customize the look of the CP590.
3.1.0 Power On/Off and ShuttlePoint Knob Operation
1. Press and hold [PWR] until the display shows the Start-Up page (see the following
picture). To turn Off, press and hold [PWR] until the display turns Off.
Figure 3.1.0 - Start-Up page
2. When the power is first turned on, two pages, the Start-Up page and the Caution pages
are briefly shown before the GPS Status page.
Figure 3.1.0a - Caution pages
NOTE
The Caution page on the left is shown only if the data C-CARD is over one year old.