Operation Manual

Page 16 CP590
Personal Computer Connection / Setup
Any of the NMEA Ports can be used to Send and Receive Marks and Routes to PC
programs. The CP590 uses NMEA WPL and RTE sentences to share information from the
PC. Refer to the table below for connection to a Serial DB9 connector.
Receive +
Transmit +
Signal Common
D9 PINB
C 590P
NMEA Out
NMEA In
Green wire
2
3
5
CONNECTION
Setting Up the COM Port
The Send and Receive default is Port1. To change the Port follow the procedure:
1. Press [MENU] twice. Move the ShuttlePoint knob to highlight
ADVANCED SETUP
and press [ENT].
2. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT].
3. Move the ShuttlePoint knob to highlight
SEND/REC RTE&MARKS and press [ENT].