Operation Manual

CP590 Page 107
a. If the received PTX is not the active one, the user must confirm to navigate to it.
b. If the received PTX is the active one, navigation data is updated. The PTX icon appears at the
new position and a popup Warning window appears.
16.4 PLACING CURSOR ON THE PTX ICON
Moving the ShuttlePoint knob so the cursor is over the PTX icon on the Chart page will show
an information window and allow you to Goto the location of the PTX, delete the PTX icon
or show the Alarm Status list as shown below.
Figure 16.4 - Example of PTX information window
16.4.0 Delete PTX
The Delete PTX function permanently removes the selected PTX from the MOBILARM
Alarm Status List and from the Chart page. Using the ShuttlePoint knob, move the cursor
over the PTX icon and then press [D
ELETE]. A Warning popup window will be shown. Select
YES and press [ENT].
16.4.1 Goto PTX
When Goto is selected on the CP590, navigation will start to the PTX icon location. After
the CP590 has received a PTX MOB alarm, using the ShuttlePoint knob move the cursor
over the PTX to navigate to and then two Soft Keys under the display will be shown:
a. [G
OTO], when pressed will start navigation to the PTX MOB location
b. [L
IST], when pressed will show the MOBILARM Alarm Status List page. Refer to Par.
16.4.2 for Alarm Status List.
Figure 16.4.1 - Example of Goto PTX