Operation Manual

CP390i and CPF390i Page 97
AUTO INFO Off
AUTO INFO On Points
AUTO INFO On All
Figure 12.0.5 - Example of Auto Info settings
12.0.6 Display Mode
Selects from a pre-defined table what cartographic objects are displayed and which display
options are set. Pre-programmed settings are user selectable from Full, Medium, Low,
Radar (reduces the information on the display to simulate items that would be shown on a
RADAR display. Please note this function is not actually showing RADAR information it is
only showing what typically would be shown by a separate dedicated RADAR display),
Tides, Custom (default mode).
To change to one of the pre-programmed settings:
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
CHART CONFIGURATIONS and press [ENT]
or move the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
DISPLAY MODE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob up or down to select the preset and press [ENT].
5. Press [CLR] or move the ShuttlePoint knob to the right until the Chart page is shown.
CHART CON
CHART CONFIGURATION
Figure 12.0.6 - Display Mode settings
The table below shows the selections for each mode:
Setting Full Medium Low Radar Tides Custom
(Default values)
Place Names On On On On On On
Name Tags On Off Off Off Off Off
Nav Aids & Light Sectors On No Sectors No Sectors No Sectors Off On
Attention Areas On On Off Off Off Off
Tides & Currents On Off Off Off On On