Operation Manual

Page 94 CP390i and CPF390i
12.0.1 Single Chart Page
WAAS 3D
Course Over Ground
4
2
Time
1
3
Chart Scale
7
4
3
2
1
5
6
7
5
6
Distance & Bearings from Fix to Cursor
Speed Over Ground
Fix status
Time To Go
(If plotter is not navigating
to a point will show --:--)TTG
Distance from Fix to Destination
(If plotter is not navigating
to a point DST will show ---.-)
Bearing from Fix to Destination
(If plotter is not navigating
to a point BRG will show --- )
o
8
8
9
Cursor Coordinates
10
9
10
Figure 12.0.1 - Example of Single Chart Page
12.0.2 Window Selections
The default is the Two Line Small window. The CP390i and CPF390i windows may be
changed by the procedure below.
FULL CHART (None)
GENERAL
1 LINE SMALL
1 LINE LARGE
2 LINES SMALL
HIGHWAY
COMPASS
Figure 12.0.2 - Data window layout
1. To change, press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and
press [ENT].
2. Move the ShuttlePoint knob to highlight
GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
WINDOWS SETUP and press [ENT] or move