Operation Manual

CP390i and CPF390i Page 23
The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5 for AIS Class
A and type 18, 19, 24 for AIS Class B. Select the used port and transmission speed by
following the procedure:
The CP390i has to be setup to be able to receive NMEA information from the AIS receiver.
1. Press [MENU], move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
PORT4 INPUT (or other Port the AIS is
connected to) and press [ENT] or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select
AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
2.4.2 CPF390i Connection Table
12VDC Power
Pin Wire Color Description Connection Example Additional Comments
1 Black Battery Ground &
Connect to Battery Ground and
Common for and signal ground
NMEA devices*
2 Red Battery Positive Connect to Battery Positive
3 Green Port3 Input Connect to Output of NMEA devices* Default is NMEA0183
4 Blue Port1 Input Connect to Output of NMEA devices* Default is NMEA0183
5 Brown Port1 Output Connect to Input of NMEA devices* Default is NMEA0183 with GGA, GLL, RMC,
XTE, DBT, DPT, MTW, VHW sentences
6 Gray Port2 Input Connect to Output of NMEA devices* Default is NMEA0183
7 White Port2 Output Connect to Input of NMEA devices* Default is NMEA0183 with GGA, GLL, RMC
and XTE sentences
8 Yellow Port3 Output Connect to Input of NMEA devices* Default is NMEA0183 with APA, APB, BOD,
GGA, GLL, RMC and BOD sentences
*NOTE
RS232 not opto-isolated electrical interface.
2.4.3 CPF390i Connections
2.4.3.0 DC Power Connection
CPF390i
Battery
10-35Vdc
Red
2A
Fuse
Black
Switch
+
-
Optional WAAS GPS
antenna
PWR & ACC 1 Cable
Transducer