Operation Manual

CP390i and CPF390i Page 21

NOTE

The GPS Chart Plotter can send many sentences to external NMEA devices*. The NMEA Output

wires are yellow and white. If you have connected devices as shown in the table on the next page

and need to feed NMEA to other devices (Autopilot, RADAR…) you can parallel wires from the

yellow, brown or white wires to other devices.

2.4.0 CP390i Connection Table

12VDC Power Cable

Pin Wire Color Description Connection Example Additional Comments

1 Black Battery Ground Connect to Battery Ground

2 Red Battery Positive Connect to Battery Positive

3 Green NMEA Common Common (ground) for NMEA devices*

4 Blue Port 1 Input Connect to Output of NMEA devices* Default is NMEA0183

5 Brown Port 1 Output Connect to Input of NMEA devices* Default is NMEA0183 with GGA, GLL, RMC,

XTE, DBT, DPT, MTW, VHW sentences

6 Grey Port2 Input Connect to FF525 Default is Fish Finder

7 White Port2 Output Connect to FF525 Default is Fish Finder

8 Yellow Port 3 Output Connect to Input of NMEA devices* Default is NMEA0183 with APA, APB, BOD,

GGA, GLL, RMC and BOD sentences

NMEA ACC 2 Cable

Pin Wire Color Description Connection Example Additional Comments

1 Black NC

2 Red NC

3 Green NMEA Common Common (ground) for NMEA devices*

4 Blue Port 4 Input Connect to Output of NMEA devices* Default is NMEA0183*

5 Brown Port 4 Output Connect to Input of NMEA devices* Default is NMEA0183 with GLL, RMB, RMC

and XTE sentences

6 Grey Port 5 Input Connect to Output of NMEA devices* Default is NMEA0183

7 White Port 5 Output Connect to Input of NMEA devices* Default is NMEA0183 with GLL, RMB, RMC

and XTE sentences

8 Yellow NC

*NOTE

RS232 not opto-isolated electrical interface.

2.4.1 CP390i Connections

2.4.1.0 DC Power Connection

Battery

10-35Vdc

Red

Fuse

Black

Switch

ACC 2 Cable - Not used

PWR & ACC 1 Cable

CP390i

Optional

WAAS GPS

Antenna