Operation Manual

CP390i and CPF390i Page 127
location. After the GPS Chart Plotter has received a PTX MOB alarm, using the ShuttlePoint
knob move the cursor over the PTX to navigate to and then two Soft Keys under the display
will be shown:
a. [G
OTO], when pressed will start navigating to the PTX MOB location
b. [L
IST], when pressed will show the MOBILARM Alarm Status List page. Refer to Par.
16.4.2 for Alarm Status List.
Figure 16.4.1 - Example of Goto PTX
If the navigation is set to the selected PTX icon, to terminate the navigation press
[S
TOPGOTO].
Figure 16.4.1a - Example of Stop Goto PTX
16.4.2 The MOBILARM Alarm Status List
The MOBILARM Alarm Status List shows the list of all PTX that the GPS Chart Plotter has
received an alarm from. To review the page:
1. Select the Chart Page.
2. Press [MENU] to show the Main menu.
3. Move the ShuttlePoint knob to highlight
USER POINTS and press [ENT].
4. Move the ShuttlePoint knob to highlight
MOBILARM and press [ENT].