Operation Manual

CP390i and CPF390i Page 125
b. Not connected/detected : possible wiring problem, confirm wires are correct con-
nected from the GPS Chart Plotter to the MOBILARM
device.
c. Connected : the communication with MOBILARM device is Ok.
d. Signal Lost : the MOBILARM has been connected in the past, howev-
er no signal is being detected from the MOBILARM.
Check wire connections from the GPS Chart Plotter to
the MOBILARM.
e. No valid GPS position : the communication with MOBILARM device is Ok, but the
GPS position fix is not received from the GPS Chart
Plotter.
See the following example of About page:
MOBILARM status Information
1
XXXXXX YY.YY
1
INTCHART 1 : WW-M012.03 MARINE FRESHWATER WWBK
BUILT-IN CHARTS: NA-Z010.00
C-CARD : M-NA-M632.00 LOS ANGELES and SAN PEDRO BAYS
Figure 16.2 - Example of About page with MOBILARM information
16.3 MOBILARM PTX
A PTX is the Personal Transponder device that is worn by the crew. If a crew member falls
in the water the MOBILARM sends a signal to the GPS Chart Plotter which creates and
displays a PTX icon on the Chart page.
16.3.0 MOBILARM MOB alert is received
When crew member falls in the water, the MOBILARM sends a signal to the GPS Chart
Plotter which creates and displays a PTX MOB icon on the Chart page.
Figure 16.3.0 - The PTX icon
On the GPS Chart Plotter all menus and/or pages are closed and the chart is centered on
the PTX MOB received position. A Audible Alarm is heard and a pop-up warning window
appears to notify that a PTX has been received: