Operation Manual

Installation

1. Remove the six screws and the washer se-

curing the Front Panel and then carefully

separate the Front Panel from the Rear case.

Connector

BU-1 Bluetooth

Adapter Unit

Please be sure to follow these safety precautions.



 Turn the transceiver power off, and disconnect all cables from the transceiver.

 

 Touch a metal place to discharge any static electricity from your body.

Double-side tape

If you use the GX5500S, disconnect the

wire from the Printed Circuit Board in the

Front Panel.

2. Locate the connector for the BU-1.

Peel the covering of the double-side tape on

the Printed Circuit Board.

3. Carefully align the connector on the BU-1

with the connector on the Printed Circuit

Board, and gently press the BU-1 into place.

4. Replace the Rear Case, using the screws and

washer removed in the first step.

Note: If you used the GX5500S, Attach the

Wire to the connector on the Printed

Circuit Board in the Front Panel.

 Be certain the Rubber packing on the Rear

case is correctly installed, and the rear

case adheres and seals properly.

5. Installation is now complete.

BU-1

Wire

PAGE 1
BU-1 Bluetooth® Adapter Unit Please be sure to follow these safety precautions. Turn the transceiver power off, and disconnect all cables from the transceiver. Touch a metal place to discharge any static electricity from your body. Installation 1. Remove the six screws and the washer securing the Front Panel and then carefully separate the Front Panel from the Rear case. 2. Locate the connector for the BU-1. Peel the covering of the double-side tape on the Printed Circuit Board.
PAGE 2
Installation of the optional BU-1 Bluetooth® Adapter Unit will enable, the GX5000S/GX5500S to send/receive voice messages with the optional BH-1 Bluetooth® Headset via wireless links. Pairing When using the Bluetooth® Headset for the first time, the Bluetooth® Headset and the GX5000S/GX5500S must be paired. Bring the Bluetooth ® Headset and the GX5000S/GX5500S close together when doing Pairing. 1. Press and hold the [CALL(MENU)] key unSetup Menu til “Setup Menu” appears. 2.