User's Manual

RM600D INSTRUCTION MANUAL PAGE 3
REAR PANEL CONNECTIONS
changing the microphones, both units should be
switched off.
Note: Only one alphanumeric microphone should be
connected to any GX600D/RM600D combination.
RESTRICTIONS OF USE
European Telecommunications Standard Institute (ESTI) has
stipulated the specific requirements (EN 301 025-1/2/3) for
marine radio with class D DSC feature. This equipment is not
for use on SOLAS vessels or vessels on inland waterways. This
remote control head to suit the GX600D is intended for use
in European countries: DK, FI, FR, DE, GR, IE, IT, MT, NL, PT,
ES, SE, GB, IS, NO AND TR.
SPECIFICATIONS
ELECTRICAL
Supply Voltage: 12 Volt Nominal
10.5-15.6 Volt Max. range
Negative earth
Current Consumption: Muted <200 mA
Full Volume 700 mA
ENVIRONMENTAL
Temperature Range: -10˚C to 55˚C
Solar Radiation: Case UV stabilised
Water & Dust Resistance: TP67 excluding external
cabling
Compass Safe Distance: 300 mm
MECHANICAL
Dimensions: 164(W) x 65(H) x 55(D) mm
Weight: 450 grams
AUDIO OUTPUT POWER
External 4 OHm Speaker: 4 Watts average
Internal Speaker: 2 Watts average
EXTERNAL CONNECTIONS
Microphone: 6 pin RJ12 Socket
D.C. Supply: 2 pin Polarized Blade Socket
External Speaker: 3.5 mm mini phono line
socket (mono)
OVERCURRENT PROTECTION
Fuse: Inline 2 Amp 3 AG
INSTALLATION
INSTALLING THE UNIT
After choosing your location, hold the unit with the
mounting bracket attached into the desired position and
mark the location with a pencil. Remove the mounting
bracket from the radio and drill the mounting holes. Bolt or
screw the bracket in place using hardware suitable for the
mounting surface. The unit is supplied with stainless steel
screws; however, if the mounting surface is unsuitable for
screws you may need to replace these with stainless steel
bolts. Remember the fixings for overhead mounted units
may have to withstand heavy pounding when the vessel is
in rough water or being towed on a trailer.
SELECTING A LOCATION
It is advisable to spend a little time selecting the best
location for your RM600D. The mounting bracket can be
rotated above, below or behind the radio enabling the radio
to be mounted in a wide range of locations. In addition,
using the optional flush mounting kits (MK600, MK001,
MK002) the RM600D can be mounted directly in a panel or
dashboard. The flush mounting kits allow for installation or
replacement of any existing VHF radio.
REPLACING THE MICROPHONE
It is recommended that the microphone be left permanently
connected to the RM600D, but if it must be disconnected,
proceed as follows:
1. Insert a small screw driver between the rubber boot
and the lip of the raised area on the front panel.
2. Ease the rubber boot out of the cable entry hole and
slide it along the cable away from the front panel.
Mounting Bracket
DC Power Cable
Extension Speaker Socket
Gimbal Knob
Remote Base
Inter Connecting
Cable