User Manual

2. Quick Reference Programming Guide

To enter the programming mode

Master code

999999 is the default factory master code

To exit from the programming mode *

Note that to undertake the following programming the master user must be logged in

To change the master code

New code

The master code can be 6 to 8 digits

To add a PIN user.

User ID number

The ID number is any number between 1 & 2000. The

PIN is any four digits between 0000 & 9999 with the

exception of 1234 which is reserved. Users can be added

continuously without exiting programming mode

To add a card user 1 Read Card #

Cards can be added continuously without exiting

programming mode

To delete a PIN or a card user. 2 User ID number # for a PIN user or

2 Read Card # for a card user

Users can be deleted continuously without exiting

programming mode

To unlock the door for a PIN user Enter the PIN then press #

To unlock the door for a card user Present the card

3. Description

The unit is single door multifunction standalone access controller or a Wiegand output

keypad or card reader. It is suitable for mounting either indoor or outdoor in harsh

environments. It is housed in a strong, sturdy and vandal proof Zinc Alloy electroplated

case which is available in either a bright silver or matt silver finish. The electronics are

fully potted so the unit is waterproof and conforms to IP68. This unit supports up to 2000

users in either a Card, 4 digit PIN, or a Card + PIN option. The inbuilt card reader supports

125KHZ EM cards,13.56MHz Mifare cards. The unit has many extra features including

lock output current short circuit protection, Wiegand output , and a backlit keypad. These

features make the unit an ideal choice for door access not only for small shops and

domestic households but also for commercial and industrial applications such as factories,