User Manual

UpTrak Standing Desk
Made in China!
www.standsteady.com
[e-mail]
1-703-688-DESK(3375)
Components Included
!
!
!
!
Directions
1. Insert the Rails:
Tip the base panel on its side and screw
in one rail at a time.
2. Add the Desktop Panel:
With the black clips facing up, sIide the
desktop panel onto the rails.
3. Add the Rail Cap:
Fully lower the desktop panel.
Then, push the rail cap onto the
four rails and screw it in.
4. Adjust the Height:
Holding the desktop panel with two hands,
slide it up to your comfortable working
height. While still holding it, use your
thumbs to lock the black clips.
!!!!
!
5. Add the Support Leg:
The support leg works the same as a
tension rod. Twist the metal parts of the
support leg away from each other, move
them to your desired height, and then
twist them back until they lock.
Tip: Use a permanent marker to mark
your height so you can reset your desk
quickly.
6. Lower the Desk:
To lower the desk, first remove the
support leg. Holding the top with
both hands, use your thumbs to
unlock the black clips. Then,
slowly glide the desk down the
rails to the bottom.
!
Troubleshooting
Desktop slides down:
Make sure the clips are fully locked.
Support Leg:
If the Support Leg does not hold, make
sure you have tightly twisted the metal
tubes to adjust the height. You should not
be twisting the end cap to adjust height.
Watch Assembly Video:
http://bit.ly/19DjHaq
Open
Locked
If you have any problems with your product, please contact us directly so that we can resolve the issue. We can be reached
Mon-Fri 9am-5pm EST at 703-688-DESK(3375) or [e-mail].
!
!
1 Desktop Panel 4 Rails (2 Thin, 2 Thick)
1 Base Panel 8 Screws
1 Rail Cap 1 Allen Key
1 Support Leg
Adjust Here Not Here