Owners manual

RAIL TOPZ (Bed Rail Caps)
INSTALLATION INSTRUCTIONS
I - Sheet Number STMP-BRI Rev.A
Stampede Automotive Products • Visit us at stampedeproducts.com • 800-241-7219
IMPORTANT: READ BEFORE INSTALLATION
IDEAL TAPE APPLICATION TEMPERATURE RANGE IS
70-100 DEGREES FAHRENHEIT!
STEP 1: PEEL THE RED VINYL BACKING PARTIALLY AWAY FROM
TAPE PADS. NOTE: MAKE SURE THE TABS ARE FOLDED TOWARD
THE OUTSIDE OF THE PART AND THAT THE MIDDLE TAPE LINER IS
IN FRONT OF THE OUTSIDE LINER Fig (A).
STEP 2: CAREFULLY LAY THE PART DOWN ON THE VEHICLE BED
RAIL AND POSITION PROPERLY Fig (B).
STEP 3: MAINTAINING PART PLACEMENT, BEGIN BY PULLING
MIDDLE TAPE TAB FIRST. APPLY DOWNWARD PRESSURE TO PART
AS YOU REMOVE TAPE LINER. REMOVE CAREFULLY. DO NOT BREAK
TAPE LINER. REPEAT FOR REMAINING TAPE LINERS. ONCE ALL
LINERS ARE REMOVED, APPLY FIRM PRESSURE ALONG ALL TAPED
AREAS.
Fig (A)
Fig (C)
NOTE: 3M™ RECOMMENDS 30 PSI TO PROMOTE FULL ADHESION. TAPE REACHES MAXIMUM ADHESIVE BOND
AFTER 24 HOURS OF CONTACT.
STEP 4: SLIDE A SUPPLIED “S” SPRING CLIP (CL1-0006) ONTO THE VEHICLE BED RAIL IN THE CORRESPOND-
ING FASTENING LOCATIONS ON THE INSIDE EDGE OF THE BEDRAIL CAP. Fig (C).
FASTEN THE BEDRAIL CAP TO THE CLIPS WITH THE SUPPLIED TRUSS SCREWS (SW1-0050). Fig (C).
NOTE: THE BEDRAIL CAP IS DESIGNED WITH A SMALL GAP AT THE FRONT OF THE BED TO ALLOW FOR EXPAN-
SION AND CONTRACTION OF THE PART. IT IS NOT DESIGNED TO COVER TO THE END OF THE BED. Fig (D).
Fig (B)
Fig (D)