Warranty

1. To store the inLINE® Back Stretch Bench Pro, simply keep it in a clean dry place.

2. Adjust the HEIGHT ADJUSTMENT BEAM(3) and MAIN FRAME(1) to the shortest position. The

inLINE® Back Stretch Bench Pro is approximately 56 inches long x 18.5 inches wide x 14 inches

tall. These dimensions will vary. Please measure your inLINE® Back Stretch Bench Pro if exact

dimensions are needed.

3. To move the inLINE® Back Stretch Bench Pro, lift by the CUSHION(12) on one end and the

HEIGHT ADJUSTMENT BEAM(3) at the other end. Use caution as the SWING ARMS(6) may move

and cause a pinching hazard.

The safety and integrity designed into the inLINE® Back Stretch Bench Pro can only be maintained

when the inLINE® Back Stretch Bench Pro is regularly examined for damage and wear. Special

attention should be given to the following:

1. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.

Tighten loose nuts and bolts.

2. Verify that the CAUTION LABEL(40) is in place and easy to read. Call Stamina Products immediately

at 1-800-375-7520 for a replacement CAUTION LABEL(40) if it is missing or damaged.

3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

4. Worn or damaged components must be replaced immediately or the inLINE® Back Stretch Bench

Pro removed from service until repair is made.

5. Only Stamina Products supplied components should be used to maintain/repair the inLINE® Back

Stretch Bench Pro.

6. Keep your inLINE® Back Stretch Bench Pro clean by wiping it o with an absorbent cloth after use.

STORAGE

MAINTENANCE

STRETCH SYSTEM

The inLINE® Back Stretch Bench Pro stretches the back with

its one way rack and pinion engineering. Lie on the inLINE®

Back Stretch Bench Pro with the ARMPIT PADS(8) under your

armpits, and the FOAM PADS(24) holding your ankles. Pull the

LEVER(13) back and forth as many times as needed until you

feel a gentle stretch. Stop pulling at the desired position and stay

at the stretched position for a few minutes. Push the LEVER(13)

rmly toward your feet to release the stretch.

Push the Lever toward

your feet to release.

Pull the Lever back and forth

as many times as needed to

reach the proper stretch.

OPERATIONAL INSTRUCTIONS