Instructions / Assembly

ASSEMBLY INSTRUCTIONS
STEP 5
Attach the LARGER HAND HOLD(14) to the LEFT UPRIGHT(4) with SOCKET HEAD BOLT
(M10x1.5x35mm)(38), WASHER(M10)(42), and NYLOCK NUT(M10x1.5)(47). Repeat to attach the
SMALL HAND HOLD(15) to the RIGHT UPRIGHT(5).
STEP 6
Refer to the illustration below. Attach the DIP ARM(8) to the LEFT UPRIGHT(4) with the SHAFT(18),
ADJUSTMENT PIN(23), HEX BOLT(M12x1.75x80mm)(34), WASHERS(M12)(41), and NYLOCK
NUT(M12x1.75)(46). Repeat on other side.
NOTE: There are seven adjustment holes on the LEFT and RIGHT UPRIGHTS(4, 5) for attaching the
DIP ARMS(8) to different heights. Always attach the DIP ARMS(8) to the same height on both
sides.
WARNING: Make sure ADJUSTMENT PIN(23) that came with equipment is fully engaged at all times.
10
8
8
5
4
14
18
18
23
23
34
34
38
42
42
47
41
41
47
46
46
41
41
15
38