Instructions / Assembly

ASSEMBLY INSTRUCTIONS

STEP 3

Insert the two UPRIGHTS(2) into the MAIN STANDS(1). Place a ARC WASHER(M10)(26) on a HEX

BOLT(M10x1.5x130mm)(21). Slide a SPACER TUBE(11) between the UPRIGHT(2) and the DIP

STAND(5), then insert the bolt through all these tubes and bolt them together with a ARC WASHER(M10)

(26) and a NYLOCK NUT(M10x1.5)(23). Repeat to assemble the other SPACER TUBES(11) between

the UPRIGHT(2) and the DIP STAND(5).

NOTE: When assembling the SPACER TUBE(11), start from the one at the lower position.

STEP 4

Attach the PULL-UP BAR(3) to both the UPRIGHTS(2) with HEX BOLTS(M8x1.25x50mm)(20) and

ARC WASHERS(M8)(25).

To assemble the SPACER

TUBES(11), start from the one

at the lower position.