Warranty

STORAGE

MAINTENANCE

LOAD ADJUSTMENT

To increase the load, turn the TENSION KNOB(21) clockwise. To

decrease the load, turn the TENSION KNOB(21) counterclockwise.

There are eight levels for the load adjustment.

NOTE: The load will increase as you pedal faster.

1. To store the Total Body Recumbent Bike, simply keep it in a clean dry place.

2. The Total Body Recumbent Bike is approximately 49.6 inches long x 23.6 inches wide x 48.6 inches

tall. These dimensions will vary. Please measure your Total Body Recumbent Bike if exact dimensions

are needed.

3. To move the Total Body Recumbent Bike, lift the REAR STABILIZER(9) and use the WHEELS(76)

on the FRONT STABILIZER(8).

4. To avoid damage to the electronics, remove the batteries before storing the Total Body Recumbent

Bike for one year or more.

The safety and integrity designed into the Total Body Recumbent Bike can only be maintained when the

Total Body Recumbent Bike is regularly examined for damage and wear. Special attention should be

given to the following:

1. Adjust the TENSION KNOB(21) and verify that it functions properly and the resistance changes.

2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that

the left pedal has left hand threads and is tightened by turning counterclockwise.

3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten

loose nuts and bolts.

4. Verify that the CAUTION LABEL(122) is in place and easy to read. Call Stamina Products immediately

at 1-800-375-7520 for a replacement CAUTION LABEL(122) if it is missing or damaged.

5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

6. Worn or damaged components must be replaced immediately or the Total Body Recumbent Bike

removed from service until repair is made.

7. Only Stamina Products supplied components should be used to maintain/repair the Total Body

Recumbent Bike.

8. Keep your Total Body Recumbent Bike clean by wiping it o with an absorbent cloth after use.

OPERATIONAL INSTRUCTIONS