Warranty

OPERATIONAL INSTRUCTIONS
12
POWER OFF:
Pedal movement or press any button.
Automatic shut o after four minutes of inactivity.
Resets all values to zero.
POWER ON:
USING THE FITNESS METER
FUNCTIONS:
SCAN:
TIME:
SPEED:
CALORIE:
DISTANCE:
PULSE:
Automatically scans TIME, SPEED, CALORIE, PULSE, and DISTANCE in sequence with a change
every six seconds. Press and release the MODE button until the “SCAN” appear on display.
Counts upward to 99:59 in one second increments once the meter is turned on. Counts down from
preset value.
Displays the current speed from zero to 45 miles per hour.
Displays the calorie consumption from zero to 999.9 Kcal. Counts down from preset value.
The calorie readout is an estimate for an average user. It should be used only as a comparison between
workouts on this unit.
Displays distance up to 999.9 miles in increments of 0.01 miles. Counts down from preset value.
Displays your pulse rate in beats per minute. To display pulse, select the PULSE MODE and grasp
the pulse sensors on the handrail, one in each hand. The heart icon will begin ashing when the
ELECTRONIC METER senses your pulse. Your pulse will be displayed approximately ve (5) seconds
after the heart icon is displayed. If the heart icon does not appear, relax your grip or change your grip
on the pulse sensors. If you preset the PULSE value, the meter will warn you with an audible alarm
when your pulse exceeds the set value. Stop exercising until your pulse comes down.
NOTE: The pulse function is a great tool to optimize your workout, but should be used as a reference only.
AA Batteries
PRESET VALUES OPERATION:
Stop pedaling for four seconds. Press the ENTER button to go to setting mode. The meter will cycle through the
functions as follows and allow you to set the function values.
Time (0:00 to 99:00) Calorie (0.0 to 999.0 Kcal) Pulse (90 to 220 BPM) Distance (0.0 to 999.9 mile)
Use UP & DOWN buttons to choose desired setting values and press ENTER button to conrm. Or, just press the
ENTER button to skip the setting and move on to the next function. After all the desired setting are chosen, press the
ENTER button to start workout.
FUNCTION BUTTONS:
RESET :
This button will reset each function to zero.
To reset all functions to zero, press the button and
hold it down for two seconds.
UP & DOWN:
These two buttons set target values for TIME,
CALORIE, PULSE, and DISTANCE.
MODE :
Press and release to select functions for display or
to preset target values.
ENTER :
Press to enter the setting and conrm the selected
values of the setting mode.
Open the Battery Door on the back of the meter.
The meter operates with two AA batteries, the batteries are not included.
Refer to the illustration to install or replace the batteries.
1.
2.
HOW TO INSTALL AND REPLACE BATTERIES:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according to
all state and federal laws and regulations.
5. Do not dispose of batteries in re.
NOTE:
ENTER
DOWN
UP
MODE
RESET