Warranty

Place the Total Body Recumbent Bike in the area where it will be used. It is recommended that the Total
Body Recumbent Bike be placed on an equipment mat. The Total Body Recumbent Bike is approximately
49.6 inches long x 23.6 inches wide x 48.6 inches tall. (These dimensions may vary up to one inch.) An
area 4 feet wide x 6 feet long is required for safe operation of the Total Body Recumbent Bike. Make
sure that adequate space is available for access to and passage around the Total Body Recumbent Bike.
LEVELING: Place the Total Body Recumbent Bike on a at surface and equipment mat to set it on
the oor without rocking. Adjust the STAND(65) under the REAR FRAME(2) to get more
support for the base of the Total Body Recumbent Bike.
MOVING: The Total Body Recumbent Bike has a pair of WHEELS(76) on the FRONT STABILIZER(8).
Lift up the REAR STABILIZER(9) to move the Total Body Recumbent Bike.
CAUTION: Locate and read the CAUTION LABEL(122) on the Total Body Recumbent Bike. Make
sure that all users read the CAUTION LABEL(122) before using the product.
SET UP INSTRUCTIONS
11
4 feet
6 feet
FUNCTION INSPECTION:
Visually inspect the Total Body Recumbent Bike to verify that assembly is as shown in the above illustration.
Check the function of the Total Body Recumbent Bike by turning the pedal and then handlebar slowly
through one complete revolution to verify that the drive train functions properly. Adjust the TENSION
KNOB(21) and verify that it functions properly and the resistance changes.
Equipment Mat
Loosen the NUT(M8x1.25) until they touch the
LEVELING STAND(65). Adjust the LEVELING
STAND(65) for leveling. Tighten the NUT
(M8x1.25) securely against the REAR FRAME(2)
to lock the stand in position.
Nut